ok, so how am I going to mount all of this hardware onto the case?
the new monstra 360mm radiator, will be mounted off the back of the case by two koolance 120mm radiator mounts.
the reservoir pump combo will be mounted off the back of the PC case, between the koolance radiator mounts, and the second pump will be mounted to the back of the PC case below the reservoir pump combo.
I will only have three of the fans with shrouds on the new radiator for now. the fans controller I have is a 35W per channel. so, I am only using two of the three fan channels, to power the 12 fans on the build now. the third channel will power all 6 of the fans on the new radiator.
the two radiators will be in a parallel configuration with each other, and the components will stay in the parallel configuration there in now.
my flow rates on the water loop, should increase from the 6.2LPM it is now, to a 9+LPM flow rate with the new setup.