Overclock.net - An Overclocking Community - View Single Post - EPDM O-Ring for KP Venom POT/DICE Working.

View Single Post
post #4 of (permalink) Old 01-03-2019, 03:25 PM - Thread Starter
richiec77
New to Overclock.net
 
richiec77's Avatar
 
Join Date: Sep 2014
Posts: 129
Rep: 7 (Unique: 7)
Quote: Originally Posted by mllrkllr88 View Post
Neat Idea!!!


I wonder about compression with high socket tension. When I bench these pots I fully max out the kingpin springs for better results and a thinner TIM layer. What would happen if you maxed out the KP springs with this O-Ring? Does the pressure cause distortion or seal failure?



I have both versions of T-Rex and the classic Venom like yours. Happy to provide whatever measurements you need. There is also a new top for Threadripper which I can give you info on as well.
Compression is minimal with these O-Rings. So I can't see it being a problem if you're cranking down the thumbscrews.

Let me shoot you a PM. I can mail off some to you as well to check out.
richiec77 is offline