Overclock.net - An Overclocking Community - View Single Post - New Aquacomputer D5 pump has become noisy after only a couple of weeks

View Single Post
post #4 of (permalink) Old 03-11-2019, 01:34 AM - Thread Starter
Zammin
New to Overclock.net
 
Zammin's Avatar
 
Join Date: Jul 2018
Posts: 831
Rep: 2 (Unique: 2)
Quote: Originally Posted by ezveedub View Post
Did you take the pump apart and check the impeller for anything in it? Might want to do that before going RMA. I’ve only had one D5 make noise and it was right after fully bleeding a system and then running it at close to full speed. Never found anything wrong inside and it was replaced by EK.


Sent from my iPhone using Tapatalk Pro
Quote: Originally Posted by SoMBrA View Post
Check impeller as suggested. Use some specific product to clean it and should be fine!

Sent from my SM-G955F using Tapatalk
I haven't pulled it from the system yet, but I did check it before installing it. While bleeding and testing the system I had an inline filter installed. However this noise only began a few weeks after the final assembly.

When I take it out I'll check it for debris again.

Primary System Specs: Lian Li PC-O11 DX - ROG Maximus XI Formula - Watercooled Intel 9900k (4.9Ghz) - Watercooled RTX 2080 Ti FE - G.Skill Trident Z RGB 3200Mhz CL16 32GB - Corsair RM1000i PSU - Samsung 970 EVO 2TB NVME SSD

Secondary System Specs: Fractal Design Define S2 - ROG Maximus X Code - Watercooled Intel 8700k (5Ghz) - Watercooled Strix GTX 1080Ti OC - G.Skill Trident Z RGB 3200Mhz CL16 16GB - Seasonic X-1050W PSU - Intel 600P NVME SSD
Zammin is offline