Originally Posted by ShrimpBrime
Now this is a very impressive build!! I mean it's big and wonderfully built. I think I read OP at 1750w of TECs!
6 X 331watt 31volt TEC's
6 X 224watt 24volt TEC's
I'm very curious the part numbers for these TECs!! I've been using a Singe TEC# 12715 Qmax of only 136W but was the largest watt TEC I could find that fit easily under most waterblocks at only 40mm. Do you have a couple of part numbers?
Maybe a suggestion for a single TEC solution?
lets start with the 224watt 24volt TEC's they are 40mm X 40mm. TEC model # 19911-5P31-15CQ-WT.
and the 331watt 31volt TEC's they are 50mm X 50mm. TEC model # 26311-5P31-17CW.
now I do suggest having the ruggedized epoxy upgrade done to the TEC's as this makes them a lot stronger, I asked for the wire upgrade to make the wires harder to pull out. this is a $20 upgrade per TEC, but I would say that it is well worth it.
The following Epoxy based syntactic foam ruggedization seals the TEC from moisture and debris AND also strengthens the TEC against shock, vibration, and shear forces.
SE = Epoxy edge seal, 2+ mm deep
SR = Epoxy Ruggedized Sealing, 5+ mm deep
SRX = Epoxy Ruggedized Sealing, 5+ mm deep, with epoxy potting to extend around lead wires following width and thickness of TEC
SRD = Epoxy Ruggedized Sealing, 10+ mm deep or complete fill
SRDX = Epoxy Ruggedized Sealing, deep to 10+ mm or complete fill with epoxy potting to extend around lead wires following width and thickness of TEC
I got the SRX upgrade.