Overclock.net - An Overclocking Community - View Single Post - Progress on a fully custom mouse.

View Single Post
post #16 of (permalink) Old 04-25-2019, 10:00 AM - Thread Starter
TranquilTempest
New to Overclock.net
 
TranquilTempest's Avatar
 
Join Date: Aug 2011
Posts: 1,669
Rep: 78 (Unique: 63)
Quote: Originally Posted by gipetto View Post
@TranquilTempest do you happen to have the ec10 footprint to share? I have a similar project on the go. I doubt i'll ever finish it though, as kicad is new to me. edit: also the 3 pin switch footprint. I'm using a 5 pin header for that lol.
Not "official" ones, but I did make some.

The encoder footprint is a little sketchy. Couldn't figure out how to get routed slots in the footprint editor, so I used round holes. Maybe you can define plated slots somewhere else, but I haven't got that far yet. I believe pins 1 2 3 correspond to A B C, but you shouldn't trust me on that.

Switch footprint was much easier.
Attached Files
File Type: txt ALPS_horzontal_encoder.kicad_mod.txt (700 Bytes, 9 views)
File Type: txt Microswitch_SPDT_D2F.kicad_mod.txt (1.4 KB, 7 views)


Last edited by TranquilTempest; 04-25-2019 at 10:32 AM.
TranquilTempest is offline