Originally Posted by wheatpaste1999
On most of the different effects types you can control brightness and speed from a data source, which could also cause the LEDs to not light up, but it doesn't look like that is applicable to your case.
Only other things you can try (or confirm that you've already tried):
1. Your LED controllers appear to only be active for Profile 1. Confirm Profile 1 is the current active profile by clicking on the Profiles tab under the Farbwerk 360 section in Aquasuite. Current profile is listed and color coded at the top of this section.
2. Under the System tab for the Farbwerk 360 in Aquasuite, check that the strips are set to "on" and brightness is 100% under the Basic RGBpx settings in this section.
3. Try a new RGBpx cable from the Splitty4 to the Farbwerk 360.
4. Try a new Splitty4.
That's about all I can think of at this point. Might need to consider an RMA for the Farbwerk 360 if the above doesn't get you anywhere.
1) Profile 1 was already active
R9 3900X+EkWb-Asus X570 Crosshair VIII Formula-G.Skill TridentZ 32Gb Rgb-Radeon VII+EkWb-Corsair MP-600 1Tb Pcie 4.0-Evga P2 850W-Asus MG279Q-Phanteks Evolv Atx TG AF-W10 Pro