Overclock.net - An Overclocking Community - View Single Post - [Sponsored] Spotswood | Vertical mini-ITX/mini-DTX Prototype Case Build

View Single Post
post #8 of (permalink) Old 08-14-2019, 01:54 PM - Thread Starter
Spotswood
Hardware Rep
 
Spotswood's Avatar
 
Join Date: Jul 2008
Location: Washington, USA
Posts: 801
Rep: 96 (Unique: 84)
Nuts can be inserted into the extrusion via small milled-out areas. By "capturing" a nut between two others (4mm long set screws are used to retain the two outer nuts), you have the ability to fasten to a fixed location (without having to drill and tap a hole) e.g. a side panel.

Name:  IMG_1850 (Small).jpg
Views: 129
Size:  54.1 KB

Name:  IMG_1851 (Small).jpg
Views: 118
Size:  64.1 KB

Name:  IMG_1849 (Small).jpg
Views: 127
Size:  72.6 KB

Name:  IMG_1854 (Small).jpg
Views: 123
Size:  46.6 KB



Last edited by Spotswood; 08-14-2019 at 02:02 PM.
Spotswood is offline