Overclock.net - An Overclocking Community - View Single Post - [Sponsored] Spotswood | Vertical mini-ITX/mini-DTX Prototype Case Build

View Single Post
post #10 of (permalink) Old 08-25-2019, 12:29 AM - Thread Starter
Spotswood
Hardware Rep
 
Spotswood's Avatar
 
Join Date: Jul 2008
Location: Washington, USA
Posts: 801
Rep: 96 (Unique: 84)
The top was milled from a 2.25mm thick aluminum sheet.

Click image for larger version

Name:	IMG_2082 (Small).jpg
Views:	2
Size:	75.9 KB
ID:	291336

Click image for larger version

Name:	IMG_2086 (Small).jpg
Views:	2
Size:	91.2 KB
ID:	291338

I still haven't decided on the design of the ventilation holes to be milled out of the top. In the meantime, I leveraged the extra length of the corner extrusions (moving them up a bit), allowing the top to "float" 2.75mm over the side panels (creating the equivalent of a 2.75-inch square ventilation hole).

Click image for larger version

Name:	IMG_2089 (Small).jpg
Views:	2
Size:	66.4 KB
ID:	291340

Click image for larger version

Name:	IMG_2092 (Small).jpg
Views:	2
Size:	52.8 KB
ID:	291342

Click image for larger version

Name:	IMG_2094 (Small).jpg
Views:	2
Size:	87.0 KB
ID:	291344

Click image for larger version

Name:	IMG_2103 (Small).jpg
Views:	2
Size:	86.5 KB
ID:	291346


Spotswood is offline