Overclock.net - An Overclocking Community - View Single Post - Shift - An ongoing tale
View Single Post
post #15 of (permalink) Old 04-04-2020, 04:13 AM - Thread Starter
AlSki.net
New to Overclock.net
 
Join Date: Jan 2020
Posts: 17
Rep: 0
Phase II
New bits arrived!!!

They almost fit. As much as I appreciate the LT120 being supplied two fans that would make it a 75mm thick block, that is not going to fit here. Instead I'm using an NF-A12x15 which is really quiet, I see what the fuss is about. The only problem there is that the supplied M3x30 screws need replacing with M3x20s. For the moment I can temporarily bush out with some nuts. The LT block is silent below 60%.

There was a fair amount of slosh from the tank, so I'm just giving it a run without any cooling duties, to make sure that the air gets trapped in the rad. I may yet top-up the pump block, but so far it seems ok. Have to see if that changes when the pump is above the rad..
Attached Thumbnails
Click image for larger version

Name:	20200403_105312834_iOS.jpg
Views:	4
Size:	3.78 MB
ID:	336896  

Click image for larger version

Name:	20200404_104741732_iOS.jpg
Views:	5
Size:	3.61 MB
ID:	336898  


Last edited by AlSki.net; 04-04-2020 at 01:13 PM.
AlSki.net is offline