So close, yet so far. Here's my "armchair review" judging the product by the pictures.
Another good looker from LL.
Aluminum LL is always good.
Innovative clamshell design for easy access.
Side panels finally slide on and use thumbscrews, unlike my PC-Q11B which uses eight tiny screws per side.
Big exhaust fan right behind where a tower CPU cooler would be.
So right now it can take PSUs high enough wattage for dual graphics cards, but can only physically fit a single graphics card no longer than around 7". Really?
If front was vented, could have had a nice direct route through a tower heatsink. As is, air has to make some convoluted turns.
Could have gone SFX PSU since it is impossible to fit enough hardware into this chassis to need more than 450W.
I understand it is to fit the board horizontally (like a Prodigy or SG05) but the case is rather wide.
Could there be a better way to do the front ports so that there aren't long cables?
Near featureless front looks almost boring.
With all the ventilation on the side panel, why couldn't it have been extended on the GPU side to cover a wider array of GPU fans?
What's with the fascination on putting "external watercooling tube holes" on "enthusiast" cases? How many people stick their radiator outside the case? I would rather see that space used for a fan controller, if anything.