Alright...close to final part list I think. Would the Arctic Liquid Freezer 120 fit on the front panel, top position, with the EVGA hybrid cooler mounted on the front panel, bottom position? And then just add an exhaust fan to the rear? Thought about adding 1-2 intake fans on the bottom as well but don't think I'll really need them.
Sure ! you will do the same thing with the pump res combo on the rear fan slot ?
I will use the same bracket to hold the pump, and I am using the same reservoir, but mines are separate (pump + res) I don't have a combo as you.
Also I will mount them in the front of the case...with the GPU in between. Res at the top of the rad...Gpu...pump at the base of the Rad, hope it makes sense
But once the top rad is in the case I can give you some measurements.
yes it does i guess you will go like JayzTwoCents build ?
I'll wait no problems !! thank you !
Have not seen hes build, it's just my "idea" of cramming everything in. Will have to check hes build.
Mine will have some top notch hardware and a 60 mm wide radiator in the front (the XE 240) so I have plenty to think about when it comes to planning and installing things in there..also will have to take in consideration all that hot air that needs exhaustion so I really need that back fan pushing things out...