I will be updating this thread as i progress.
Tomorrow i will be picking up some of the supplies needed for the desk itself and will be ordering some new fittings/cables.Desk and Rig Before Work:
Well....i live in an apartment....so where the hell do i put it all......
i wish i had pics of what my kitchen looked like before i took it over...
my girl isn't too happy...but it's my damn apartment...i do what i want!!
Well i have everything i need to get started.
I should have a lot of it laid out before the end of tomorrow.
Gunna order PC parts once i have the desk started.
i decided to go with cam bolts.
i measured everything out and set some cams into the top of my desk.
here's some unfinished cuts i have. i need to modify them a bit.
i drilled out the holes for the cams...going to get the bolts in the sides when i get home today.
i ran into a small problem, the wood seems to have warped a bit when i cut it, now i gotta soak it and get some weight on it before i get too far so i done screw up any measurements
EDIT: Fixed warping by soaking wood in extremely hot water and then placing them on workbench with a few 45 pound weights on them