Got a small update for you all here.
Added a hole and re-used one of the many many grommets that came with case. I feel like it came out really nice. Only down side was me breathing in a ton of dremel dust trying to get a good view.
As you can see it's in a nice position to run all my PSU wiring through.
Just a couple more overview shots. As you can see it's filthy in there again.
Also I finally got my frozencpu order today. Placed this order on Sunday night and I don't think they shipped until Tuesday. O'well been kinda busy watching the Tigers after work anyway.
So here is what I got:
6 Akasa Viper 140mm fans
2 250 ml Bitspower res'. I really have to say, these Bitspower res' blow away the one EK res I decided to get. The build and material quality is just so much better.
Had to set em' up on one of the rads to see how they would look/fit.
Finally everything all laid out together.
Soo, that brings me to my next question for you guys. Although they are awesome fans, I didn't realize when I bought them that they can't be disassembled.
That means that attempting to paint the blades just became a heck of a lot harder. So I'm contemplating leaving them yellow. It's not thaat far off from my green I guess. What do you guys think?So my to do list:
Paint fans (or not)
Fit res' install mounts
Drill/cut holes for tubing
Test mount rads!To order list:
7 more Akasa Vipers
Bitspower Top/Dress kit
Fan controller (looking for suggestions here)
Eventually after getting most everything into place I will likely need more fittings.
Also eventually sleeving supplies.
Thanks for stopping by!