- power up the system, all ok, the pump it is at 4800 rpm with flow around 80L / h, and after 30 min arrive at 50 / 55L/h
- the system it is in pictures, i know i use a lot of 90/45 adapters, but ***, really choke the pump like this?
- i use one quadro with simple flow-meter from aq
- the rad = 2 xspc 360 / 50mm
It is pump defective?
The flow-meter defective ?
Or i do something wrong?
It is one old ek - lowarra mark on it - with red arrow on the position 5.
The pump it is connect direct on the molex from psu, and the blue wire with 3 pins fan connector go to fan 4 connector from Quadro AQ.
That 3 pins connector have only 1 wire on it
The pump go all time full - 4827 rpm - no matter i move the slider for fan 4 from Quadro.
Yes, when power up the pc, the flow it is around 80L/h and slowly, in around half of hour go down around 50 - 56L/ h.
I think to flow-meter too, but it is a spinning propeller, nothing more, it is high-flow sensor from AQ, the only one who is compatible with quadro.
But still, the pump claim to work at 1500L / h, from that to 50L/h, it look like i have dirt inside loop
The rad are new, cpu / gpu wb was opened and clean.
No idea from where to start diagnose that situation
I'd ditch the flow meter and just use a temp sensor instead a lot more useful.
Try to back the dial down just a tad from
Over turning I have a d5 watercool vario not installed anymore but it did not like to be turned to far past 5 or it would actually slow down
Tap it and it sped up figured it was a defect just not worth rma to Germany so it's on wall of shame now as unreliable.