|Topic Review (Newest First)|
|03-13-2015 02:13 AM|
I had the same prob, but! It´s in the BIOS, according to your specific BIOS, some settings are off! Or should be turned on! It´s specific to your BIOS, thus makes it hard to find solutions for!
|02-23-2015 03:05 AM|
i never got such problems.clr cmos is clearly hardware level
|02-23-2015 02:54 AM|
300FSB will boot and then refuse to reboot untill you fully turn it off then boot up again
|02-23-2015 02:50 AM|
you did it wrong if it didnt reset
|02-23-2015 02:49 AM|
Quote:Wrong old computers will not reset even if you use the jumper
You need to take away the battery run it for 5-10mins and never put the battery in and then power off use jumper and then put the jumper onto normall then
it will boot and reset
That is what it took to reset my dads computer the chinese brand mobo on the old am2 cpu
Newer gen mobo like my 990fxa gd80 only needs to have 1Sec - 3 sec jumper short circuit
and it will be reseted
|02-23-2015 02:48 AM|
nothing hard.just open the case, find the jumper, move the jumper for a secs or 5 secs, move it back, bingo.
boards nowadays even have clr cmos button.so easy
|02-23-2015 02:31 AM|
|02-22-2015 07:55 PM|
Quote:i learned to reset bios before i learned how to OC
Originally Posted by Iwamotto Tetsuz
Hint I had learnt how to reset bios before I started to overclock
|02-22-2015 05:37 PM|
Quote:Hint I had learnt how to reset bios before I started to overclock
Originally Posted by sakae48
recently i added a GPU to my system after a long sleep like a week ago..it works great at the first (overclocked my CPU at 3.3GHz w/ undervolt like 200~300mV)
but like 2 days ago, my PC started to act strange.everytime i turn her on, she just don't give any response!.no beep, no POST.i have 2 RAM here, and i found 1 of them were bad.
but it's not the main problem! .she still act the same!.unless i reset the cmos, she just wouldn't boot.and everytime i want to set up the bios, she wouldn't respond again!.she just shown a underscore blinking on the corner.
i wonder if this is caused by the RAM, or the PSU, or the board?.i'm sure my GPU is fine.i run it w/ kombustor, not even 1 artifact spotted, no overheat.
|09-10-2014 08:09 AM|
well..just an update..did searched for a new PSU today but i couldn't find FD Newton R3 (out of stock).Enermax Lepa (600 or 650?), FSP, and many more also out of the damn stock.
the only thing i can get is corsair cx600.bought it in doubt, but found out they were CWT DSA II..well, i hope this would last long..and i got no problem until now..no more coil whining except my old hitachi drive
|This thread has more than 10 replies. Click here to review the whole thread.|