|Topic Review (Newest First)|
|12-28-2019 06:23 PM|
I finally finished the side panels.
|11-14-2019 11:23 PM|
Refining the PSU mounting bracket continues.
The bracket was tweaked to allow removing the intrusive support beam:
35mm thick fans could be used with a 185mm long GPU:
The fabrication of the top sheet was flawless.
Finally, completed the SSD/HD mounting bracket .
|11-12-2019 10:04 AM|
Also working on a smaller, simpler variation of the OP case design (for ITX-size GPUs).
|09-26-2019 11:52 AM|
makerbeam = adult erector set.
i r in love. Will definitely find a use for this stuff when I build my new desk.
|09-26-2019 11:42 AM|
Spent some more time reducing the size of the case.
Note the square corner posts in this model:
Side panels could be any color or material. Black/ebonized oak would look beautiful.
|09-07-2019 10:06 AM|
I tell this to every maker willing to listen, so here goes to you too
Trends are a fact of life;
I remember hating my reading glasses, because they covered half my damned face (and i felt like an idiot); fast forward it a bit and it's a trend all of a sudden.. 15yr olds (of all real ages) walking around with 70s-styled glasses on them.. fashiun!111!
I could go on, but point hopefully taken.
So on topic, am aware it's the new trend to cram everything in as tight an enclosure as humanly possible; slap some needlessly overpowered GPU in it, must-have RGB on it and call one's self.. whatever it is they call themselves.
For normal people however, mITX used to be.. mITX really.. you'd use the integrated graphics, so barring that PSU lying somewhere inside the case, your sole 'worry' would be the HDDs. Tidy, logical. No empty space inside wasted. Amazing thing, logic, is it not.
Enter trends and what happens when everyone adhers to them, ie mITX cases about as deep as a full tower; why? Who knows?
Make something compact that doesn't expect the user to have a dedicated GPU; ie something that isn't almost 3 times as deep as it should; ie something resembling what once was a typical mITX case; the kind no one, but no one makes anymore.
Who knows huh, someone might buy it.
|09-03-2019 07:13 AM|
|08-31-2019 03:04 PM|
|08-31-2019 01:59 PM|
|08-30-2019 03:50 AM|
Nuts can be inserted into the extrusion via small milled-out areas. By "capturing" a nut between two others (4mm long set screws are used to retain the two outer nuts), you have the ability to fasten to a fixed location (without having to drill and tap a hole) e.g. a side panel.
Just found some M3 x 3mm set screws I am going to use on my MakerBeam (10x10mm) case!
Is the rectangle cutout at the back only for the I/O cables?
It looks big, what height is it?
|This thread has more than 10 replies. Click here to review the whole thread.|