Overclock.net banner

1 - 2 of 2 Posts

·
Registered
Joined
·
335 Posts
Discussion Starter #1
so i just ordered 3 125watt peltiers. i didnt know that wasnt enough for direct die, what is a good peltier for my proc., and i was thinking of making a water chiller, anyone know where they make metal resiviours, i was just thinking of attaching one on the side.
 

·
Registered
Joined
·
618 Posts
Quote:

Originally Posted by mrhandy65 View Post
so i just ordered 3 125watt peltiers. i didnt know that wasnt enough for direct die, what is a good peltier for my proc., and i was thinking of making a water chiller, anyone know where they make metal resiviours, i was just thinking of attaching one on the side.
For starters unless you are using Ultrasonics "2 x 50mm" waterblock you aren't going to use more than one TEC for direct die there is not enough room.

You could use them for a chiller but again you really wanted more beefy TECs but three of them wont be bad.
You don't need a metal reservior....if your thinking of putting the TEC on it you are better cooling a small quantity of coolant many times rather then trying to cool a large volume of coolant.

Look at this :- http://www.xtremesystems.org/forums/...d.php?t=238291
and you don't need to get someone to make this for you customthermoelectric do some waterblocks suitable for what you want but they aren't cheap :- http://www.shop.customthermoelectric...1.qscstrfrnt05
Bear in mind you will need two of them ...one for each side of the TEC.
 
1 - 2 of 2 Posts
Top