Overclock.net banner
1 - 6 of 6 Posts

·
Registered
Joined
·
3,473 Posts
Discussion Starter · #1 ·
Ok i found this heater core along with others, but this one has a input of 3/4" and an out-put of 5/8" 3/4 is bigger than the half in im buying, actually so is the 5/8". so how do i make this heater core work with a 1/2" water cooled system?
 

·
SNERP!!!
Joined
·
4,183 Posts
Quote:


Originally Posted by Blue_Fire

adapters? i can buy fittings anywhere. what i want to know is what kind of pressure loss and gph fluctuation im looking at here?

You aren't looking at pressure loss, because the biggest fittings on blocks are 1/2". All you have to do is put the ends of the tubing in hot water for a minute or so and then push them on the tubing after you have cut it down past the 5/8" to 3/4" on the heatercore.
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top