Overclock.net banner
1 - 4 of 4 Posts

· Registered
17 Posts
Discussion Starter · #1 ·
I ran into problems initially. I bought two new drives, and took my old drive put them in a RAID so 3x750GB. Then I couldn't get windows to install, removed the old drive resetup the RAID with only 2 and it installed perfectly. So I am using the WD utility at the moment to write 0s to all 3 drives.

I was thinking about short stroking, all I need to do is set the RAID Array to a smaller capacity right? Would 1500GB be low enough for all 3?

Here are my results in Windows 7 with 2 drives

2 X 750GB Western Digital Black

1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.