[Project_2501]

4GHz is all I really want for bragging rights, at stock voltage what would my temps be like using something like a Cooler Master Hyper 212+ EVO, and a higher rpm fan?

 

[Nihilo]

Your temps should be really good at that speed and stock volts. Might be even better if you did offset volts, could possibly get it lower. But temp wise, you'd probably barely break 70s at full load.

 

[Project_2501]

60c seems too hot for me. maybe I should use a better air cooling solution?

 

[Nihilo]

That's at FULL load I'm saying...like during stress testing. Your cooler is just fine for your purpose. These chips can handle a LOT of heat.

 

[Project_2501]

thanks

 

[Hatchet]

At 100% Folding Load, my 3570 @ 4.0 1.11v would peak at 56C w/ 20C ambient. (Im using a h80)

 

[chuckycheeze]

with my H100 I max at 50c on 4GHz @ stock voltage.

 

[Coolwaters]

Quote:

Originally Posted by chuckycheeze

with my H100 I max at 50c on 4GHz @ stock voltage.

voltage varies from chip to chip mobo to mobo.
you didnt leave it on auto did you?

 

[chuckycheeze]

No I switched it to manual. However, I upgraded my ram yesterday from 4gb Corsair Vengeance to 16gb Samsung 30nm. I think the additional ram allowed P95 to stress my CPU more heavily, and I averaged 55C after 12 hours of blend. So that's pretty close to what Hatchet got.

I need to put my push fans on now though. I only have a pull setup at the moment due to the Corsair RAM's heatsink interfering with push fan placement. Since this Samsung ram is shorter than the RAM retainer clips on my MOBO, I can now mount some push fans and hopefully lower my temps a bit.