[lewblue83]

ok when i first installed my 5870, the scaling is factory set to like 10% or something, which leaves a black boarder around the screen. so i set the scaling to 0% so it fills the entire screen.

problem is it WONT save the setting. when i restart my computer i get the same stupid boarder around my screen, and when i go in to the scaling settings it says its still on 0% but it wont change unless i move the slider again.

so annoying!

any ideas on a fix for this?

 

[Dtrain]

I believe this is a problem with the 10.8 Drivers. It does the same thing when I restart my pc but after a week or two it just kind of fixed itself. Just right click CCC and exit and the scaling fixes itself or you could always downgrade to 10.5 or upgrade to whatever's newer would be the only fix I can think of.

 

[Norlig]

Change resolution to the monitors native resolution?

 

[DuckieHo]

I assume you are using HDMI? Switch to DVI if possible.

 

[lewblue83]

ok im using the 10.9 drivers, the resolution is at the native 1920x1080 so thats not the problem.

and my monitor only has an HDMI input. but im using the DVI port on the card itself. its a DVI-HDMI cable.

 

[PcKiller]

Using a DVI cable will fix it. I know. I had the same problem.