Overclock.net banner

1 - 3 of 3 Posts

·
Registered
Joined
·
709 Posts
Discussion Starter #1

·
Premium Member
Joined
·
4,640 Posts
that site sucks, i ordered 3 yate loon from the, they sent only sent me 2, called twice emailed the a couple of times told them i was gonna file a claim through paypal. the ended up refunding me for the third fan. i mean can you forget the third fan
 

·
Registered
Joined
·
2,932 Posts
I just bought one of those from xoxide. I'm impressed with it. It starts spinning with the bare minimum voltage my scythe kaze master fan controller can provide. If I move the fan controller even slightly from the off position the spin right up to 300 rpm. They max out at 1500 rpm just like they should. I'm impressed with the noise level. They must have good bearings because the only noise is wind noise. They are a little loud at 1500 rpm but I think any fan would be that loud at that speed. At 1000 rpm they are still very quiet and move a lot of air.

People seem to talk smack on those fans but I'm impressed. I have a few other fans to compare it with. I'll do a little shootout and decide which one works best as my heat sink fan.
 
1 - 3 of 3 Posts
Top