Overclock.net banner

1 - 5 of 5 Posts

·
Registered
Joined
·
3,166 Posts
Discussion Starter #1
Hey all, i'm trying to source some parts for a water cooling project (here's the link).

I was originally planning to just use 1/2" aluminium tubing but it is very difficult to seal properly. So where can i get some 1/2" aluminium barbs in Australia for cheap?
 

·
Premium Member
Joined
·
5,037 Posts
I'm not sure if anyone even makes them, because you'd have to have an aluminum radiator and waterblock to avoid corrosion, and I've never even seen an aluminum waterblock (except for the one you've made), unless Thermaltake uses them.

Would it be possible to just use acrylic barbs, or are you welding it?
 
1 - 5 of 5 Posts
Top