Overclock.net banner
1 - 3 of 3 Posts

Premium Member
3,789 Posts
Discussion Starter · #1 ·
I was cleaning out my Antec 900 today and that bottom panel where my power supply sits on has a crease in it due to the weight. It's not very big and not very noticeable but it's there... I can put some force on it and it'll bend back into position but when I let go it'll go back to what it was before. I thought the A900 was one of the higher quality cases?

It can't really be seen in pictures. More of the angle you look at it from and where the light hits it.

Will Antec ship me a replacement or what? I just bought it in December.. And since shipping a case to Antec is going to be costly..

1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.