Overclock.net banner
1 - 3 of 3 Posts

·
Registered
Joined
·
16 Posts
Discussion Starter · #1 ·
I got it stable at 4GHz by raising the multiplier to 20 and increasing the CPU voltage to 1.35 (I think?). I heard that overclocking the FSB gives better performance so I started with that. I set the multiplier to 19 and the FSB to 211. My question: Do I need to lower the RAM speed and HT link speed to stay near the original value? Should the HT link speed and RAM be a little under or over the original. When I run Prime95 and it fails, do I raise the CPU voltage or the North Bridge voltage?
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top