Overclock.net banner
1 - 11 of 11 Posts

·
Registered
Joined
·
310 Posts
Discussion Starter · #8 ·
The window is attached using a very simple method really I measured equal distances apart and then drilled 4 small holes.

I used motherboard mounting nuts and attached them to these 4 holes.

I then measured the exact same equal distances on the side panel and cut 4 holes as well.

I then used some cut down thumb screws and it was done.

I finished the window by putting some black backing alond the edges.
LL
LL
LL
 
1 - 11 of 11 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top