CoolerMaster HAF 932 + bay resevoir

393 Views 2 Replies 2 Participants Last post by Chaz351, Nov 27, 2009

Chaz351

Discussion Starter · Nov 27, 2009

I am configuring a water cooling system for my HAF 932. I want to use a 5 1/4 Bay resevoir filling the resevoir using the fill hole that is located on the top of the case. However, I cannot find one that can accomodate 1/2" tubing with a g 1/4 fitting. Any thoughts?
Chaz351

Save

1 - 3 of 3 Posts

Juggalo23451

· #2 · Nov 27, 2009

I think you need to get a dangerden fill port. (Pls look to make sure I am right, reading the manual)
http://www.crazypc.com/products/934260B.html

Save

Chaz351

Discussion Starter · #3 · Nov 27, 2009

Thank. I thought I had mentioned that the fill hole on my HAF 932 is on the left side of the case and the the fill holes on resevoirs I am looking at are either in the center or right hand side. I would probably add a couple of extra inches of hose so I can pop out the resevoir for filling, but if I did not need to I would rather not.

Save

1 - 3 of 3 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month