Overclock.net banner
1 - 3 of 3 Posts

· Registered
1,234 Posts
Discussion Starter · #1 ·
I have this case here.


It has this big cut out metal design on the side, that I think sucks. I'd much rather have just a big clear window. I can remove the acrylic to get at the metal and I want to cut off the design, making simple right angle corners. The metal is only about 1mm thick. What's the best thing to cut with? Tin snips and a file?
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.