Overclock.net banner
1 - 6 of 6 Posts

·
Registered
Joined
·
302 Posts
Discussion Starter · #1 ·
I was trying to mount a 50mm fan that I sawed off of a Pentium III heatsink onto my NB when it got a bit wobly (I was a bit ruff I think
). Like the thermal paste unstuck. Do I need to reseat it?
 

·
Registered
Joined
·
302 Posts
Discussion Starter · #5 ·
Quote:
It sounds like you´ve bumped one of the push pins loose.
You shouldn´t need to reseat it , just check the pins are securing that HS down properly.
I think you're right, thanks.
 

·
Registered
Joined
·
302 Posts
Discussion Starter · #6 ·
Wow.

The push pins are in but it is not on tight. It's effecting my cpu temps A LOT aswell (used to be 60 C max @ 4.2GHZ now its 68 C max and higher idle temps too!) I don't know how to seat the heatsink any better because you can't tighten the HS by the looks of it??? HELP!
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top