Overclock.net banner

1 - 8 of 8 Posts

·
Registered
Joined
·
3,023 Posts
Discussion Starter · #1 ·
Well looking into mounting an exterior rad on the back side panel of my case. And right now I'm really liking the Phobya 200.2 rad for it's size and specs (would fit nice and snug and be better then a square 480 rad). The fans I'd like to put on it are two Bitfenix Pro 230 x 200 x 30mm.

linky

If you look in the specs it lists this fan as a 230 X 200 X 30mm fan. I'm guessing the 200mm length is from the flat side of the fan. Do you guys think I could mount two of these on the Phobya 200.2?

Edit: Changed pic for linky...
 

·
Registered
Joined
·
3,023 Posts
Discussion Starter · #4 ·
Quote:
Not exactly, the side of the bitfenix 230's is flat like the antec bigboy 200 fans. The measurements for the flat side is 200mm... ahh what the hell, the side will fit, it'll be the mounting holes I'll have to re-drill I'm sure. Meh, I've done worse... =P
 

·
Registered
Joined
·
771 Posts
Quote:
Originally Posted by Rognin View Post

Not exactly, the side of the bitfenix 230's is flat like the antec bigboy 200 fans. The measurements for the flat side is 200mm... ahh what the hell, the side will fit, it'll be the mounting holes I'll have to re-drill I'm sure. Meh, I've done worse... =P
This is OCN,make it fit
thumb.gif
funny avatar
biggrin.gif
 

·
Registered
Joined
·
3,023 Posts
Discussion Starter · #6 ·
Quote:
Originally Posted by shineon2011 View Post

This is OCN,make it fit
thumb.gif
funny avatar
biggrin.gif
I wonder why I even started this thread in the first place...
biggrin.gif
 
1 - 8 of 8 Posts
Top