Overclock.net banner
1 - 2 of 2 Posts

· Registered
1,466 Posts
Discussion Starter · #1 ·
During post, when I get to the screen that shows my RAID0 array, one drive has the message "Error Occurred (0)" in red. Everything starts up and run fine except the RAID array fails the WD test, with "too many bad sectors". If I check it with HD Tune, I get NO bad blocks. I figured it is a bad drive, so I already contacted WD and they're RMA'ing me a new drive.
Now I rad somewhere that it might not be the drive at all. It could be the memory or something else. Has anyone else heard of this? I ran memtest and got no errors. What next? Just swap out the drive and hope for the best?
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.