Overclock.net banner

1 - 3 of 3 Posts

·
Registered
Joined
·
15 Posts
They are DIN 7984 screws probably M4 and varius lenghts
 

·
Registered
Joined
·
268 Posts
Discussion Starter #3
Thank you EK support was kind enough to get back to me on this. There reply below perhaps helps someone else like me looking for this info.

Thank you for contacting us.
The size of the screws that you marked in the photo (the ones that hold together a copper base and Plexiglass) is M4x8 DIN7984. They are the same as the ones for the Terminal, just shorter.
We have them in the Nickel version as well and they can be purchased directly from us.
Recommended torque for assembling it is 3.

Best regards, Grega
 
1 - 3 of 3 Posts
Top