Joined
·
7,734 Posts
Hi there,
As some of you may know, the EK Spin reservoir can be a little loud sometimes. When I was bleeding some air out of the loop, I notice that it became significantly quieter when the water was pushing towards the flow metre. I have noticed that there is a maximum fluid mark but was wondering if there were actually any consequences for going slightly above this?
It would help with noise and stop the amount of bubbles formed in the reservoir. Thoughts?
As some of you may know, the EK Spin reservoir can be a little loud sometimes. When I was bleeding some air out of the loop, I notice that it became significantly quieter when the water was pushing towards the flow metre. I have noticed that there is a maximum fluid mark but was wondering if there were actually any consequences for going slightly above this?
It would help with noise and stop the amount of bubbles formed in the reservoir. Thoughts?