EK waterblocks on 780i board

229 Views 4 Replies 3 Participants Last post by Eddie3dfx, Mar 10, 2009

MisterAutomatic

Discussion Starter · Mar 9, 2009

Hey guys. I got EK - nb 780i waterblocks for my northbridge/mcp and southbridge and one other I can't remember (tired). I keep looking at the instructions, but I can't figure how the order of the washers suppose to go so I won't short the board out. Putting them on seems simple enough, but I can't tell if there are suppose to be washers on top of the mobo.

Save

1 - 5 of 5 Posts

MisterAutomatic

Discussion Starter · #2 · Mar 9, 2009

Dang, no one?

Save

DuckieHo

· #3 · Mar 9, 2009

Instruction Manual: http://www.ekwaterblocks.com/downloa...stallation.pdf

Save

MisterAutomatic

Discussion Starter · #4 · Mar 9, 2009

Quote:

Originally Posted by DuckieHo

Instruction Manual: http://www.ekwaterblocks.com/downloa...stallation.pdf

I saw those, but I still wanted to know if all the washers went under the mobo and not any above on the mobo.

See less See more

Save

Eddie3dfx

· #5 · Mar 10, 2009

Quote:

Originally Posted by MisterAutomatic

I saw those, but I still wanted to know if all the washers went under the mobo and not any above on the mobo.

Careful, there is one problem with the ek 780i block, depending on what revision you get.
You would have to google it, but type EK 780i shorting

Yes, washers are needed above the mb.

See less See more

Save

1 - 5 of 5 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month