Overclock.net banner
1 - 2 of 2 Posts

· Registered
Joined
·
1,394 Posts
Plug the drive into drive 3 and boot the computer and see what it says when the Intel controller initializes. If it show degraded boot the computer and run the intel raid manger and rebuild the array. If it says good your fine. I have moved Raid ) from one Motherboard to another with no problems and it saw the array fine. I have even moved a Raid0 Array from a Dell Perc5/i card to and intel controller with no problems.
 

· Registered
Joined
·
1,394 Posts
If after you do this the intel controller say degraded for the on in port 1 and non raid disk in port 3, which I doubt, then boot into windows and recreate the array with the Intel raid manager and just setup the drives as before.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top