ep45-ud3p overclocking

Here is my template for Q6600 at 3.861 (429*9) for reference.
I've tested it out to 60 IBT stable and 33hrs p95 stable.

LLC - ON
Cpu Vcore - 1.4875
PLL - 1.5V
Cpu Ref- 0.992 (0.667 of Cpu Vcore for 65nm quads)

MCH
Mch Core - 1.5V
Reference - 1.017V (0.667 - 0.691 of Mch Core for 65nm quads.)
MCH / Dram - 0.9V (make that 0.5 of Dram Voltage )

everything else was on auto.
Also this should be of help to you especially:
DRAM Termination
Channel A Ref
Channel B Ref

I'm guessing that your MCH Core might be the problem.

Quote:
Well what are your settings?

And I hope you didn't try to use my cpu vcore setting.

Quote:
nono
i set 1.55vcore
went off your .667 of it for such and all
ram was on 2.14
did the .5 of that etc

Quote:
Well whats your MCH, MCH ref, PLL, Cpu ref etc..

Quote:
same used in that link,
i tried same in link, and general same, and ref i went by what i had

Ok, promised to post my voltages so here goes:

CPU PLL - [normal] (use 1.57v near 500FSB or up)
CPU termination - 1.22v
CPU ref - [normal]
MCH core - 1.26v
MCH/DRAM ref - [normal]
MCH ref - 0.752v
ICH I/O - 1.5v
MCH strap - 333

Personal CPU/Mem settings:
CPU vcore - 1.35625v
DRAM voltage - 1.96v
DRAM termination - 0.98v (this should be half of your DRAM voltage!)
Memory multiplier - 2.40B
Channel A/B ref - [normal]
CIA2 - disabled

Formula that works for quads:
CPU termination x 0.63 = MCH ref.

Quote:
Did you try the formula I listed at the bottom of my post? I know a guy that got his quad to 530FSB by doing that.

Quote:
yep

is there anything that can tell me all current volts in windows?
bios doesnt give you a current voltage on auto