anyone else can confirm the change temps?
Congratulations! As I said above what they thought when they put such a terrible thermal interface.
I've written about this before. Of course, change it if you have any experience with it.
cool, I have experience, I will replace with Thermal Grizzly Kryonaut, thx
If you want your CPU to run @ max speed 24/7 you can use the high performance power plan in Windows.found a sulution for this and that! since i installed 3 new bioses and was able to use the rgb thing in all, what u need to do is go into bios save all your settings to a profile, select that profile exit and then u can turn on rgb, its biosprofile based, u can switch the rgb for what profile u have selectedi only understod this now since i flashed 10c today and had the orange thing now, and i did not do the profile setup yet it did not work, gotta save the profile and select it, restart and now it works again like it did before
btw anyone knows of a setting in bios were u can make the oc of the cpu be at max frequency at all times? i dont want to have it underclocking itself when i oc!
I`ve put the pad in a safe place .. if i ever have to send back the MB i`ll clean it up and put the pad back. There are no warranty seals on the 4 screws of the Chipset radiator.
Sounds like the PBO Bug isn't fixed…
Sounds like Gigabyte should bring an update fast...
I set the limits manually, complete in all options, CBS and overclocking, at least PPT.
Would be great - wasn't lucky so far to push my RAM beyond 3535 MHz (G. Skill - F4-3200C14D-32GTZR) - no go - and I tried for hours with D-RAM Calc etc. - but I have 4x16GB.Hi all, F10C work well for me.
My memory is gskill F4-3200C14D-32GTZ (2x16) and i ve found a really simple setting to oc at 3600,3733 or 3800. Tested few days with all bios version, in real condition (long game session, compilation archlinux, rendering,etc..), work very well without crash or problem.
Before: xmp profile enable,select your frequency, ddr voltage 1,42, 16 16 16 16 32 48, vddg 950, soc 1100, cad bus 24 24 24 24, proc odt 53,3, and play with tRFC for low latency. Select your IF frequency.
Now: xmp profile disable,select your frequency, ddr voltage 1,35 (work @3600,3733,3800), 16 16 16 16 32 (don t put 48 or other value, stay in AUTO) . All others settings in AUTO . Select your IF frequency.
Your latency will be @67ns (not the best but very good) , but stable, no crash, don't need high voltage and don t spend time to try different tweaks just for 2-3 ns for nothing.
It s very simple and you stay @1,35v for 3600,3733,3800
Hope it work for you too , for me i stay @3733, better boost and results.
Well ist a bug - when setting EDC to 0 it defaults to 140A - but you cannot set it to any higher value - any other value will trigger the bug.
As I said...it's the known PBO bug…Any other value than 0 in EDC will kill your boost with BIOS Rev. F10a.
