Overclock.net banner

1 - 5 of 5 Posts

·
Registered
Joined
·
701 Posts
Discussion Starter · #1 ·
Received my 295 today that I got in a trade, unboxed and put it in my system, installed the 6 pin and 8 pin to it, booted the computer...display is not coming on. Monitor is receiving power and the computer is booting\\getting to windows but the power button just flashes from not getting signal.

My PCI-E cable is a 6pin +2 pin, and I installed the 2 pin on the left side of it, if I biased the 6 pin to the right of the card, either this is backwards or my card is not seated all the way in the PCI-E. I dont think it will be any other issue.

Was running 196.75 drivers on the 275, basically pulled that card out and plugged the 295 in.
 

·
Registered
Joined
·
3,315 Posts
did you uninstall the card from device manager before you plugged the new one in ?
 

·
Registered
Joined
·
701 Posts
Discussion Starter · #4 ·
Quote:


Originally Posted by rmp459
View Post

did you uninstall the card from device manager before you plugged the new one in ?

Did not.
 

·
Registered
Joined
·
701 Posts
Discussion Starter · #5 ·
Problem sorted out. Turned out to be a Suddenly bad PCI Express slot
So running it on the second one, debating to RMA the board or not.
 
1 - 5 of 5 Posts
Top