Overclock.net banner
1 - 4 of 4 Posts

·
Registered
Joined
·
1,702 Posts
Discussion Starter · #1 ·
ok when i try and oc, i turn the fsb up just a tad past 210 and drop the multi just a tad down to 10x from 11x. and then it becomes unstable and i have to reset cmos. why is this? what can i do? my psu should be able to do a bit of an oc on 18a @12v. I no not much but some right? my temps are a tad high (53 load) but other than than that I wanna know why I cant oc?
 

·
Registered
Joined
·
1,702 Posts
Discussion Starter · #3 ·
on DFI motherboards what the HTT called? and do socket 754 have htt? or is it socket 939 only?
 

·
Premium Member
Joined
·
45,674 Posts
The 12+v rail is a bit low for your system. 24a is recommended with a singel power in vid card for stable OCing.
I saw you got the HTT ahswer in your other thread

As said.. reduce the LDT (Memory Controler) multiplyer.
As you OC you may need to increase the LDT's voltage along with the nForce chip.
You also seem to be getting high CPU temps... with that XP-120 something is a miss because it should do very well to keep the CPU cooler. A reseat and reapply AS5... the AS5 may be excessive... use very little, just a very thin film and dont spread it with your finger, use something plastic.
 
1 - 4 of 4 Posts
Top