Overclock.net banner

1 - 18 of 18 Posts

·
Premium Member
Joined
·
2,502 Posts
Discussion Starter #1
ok so as we all know I have been having watercooling trouble

I decided to let the as5 sink in a little and now I'm doing alot better

I have been slowly pulling up the Vcore to check on how much I could Pull it up if I get new ram to break my 2.45 oc

I am at 1.6 now and my temps are 43 idle and 46 load

how is this now?
 

·
Premium Member
Joined
·
3,990 Posts
Ugh, you guys all got it lucky, my room temps are only 12c... so I'm always freezing my balls off when I go to sleep.. lol.
 

·
Premium Member
Joined
·
13,844 Posts
we use wood as an auxiliary heating medium, we have an oil heat system that's our primary heating system....but i need it to be 19 up here so our pipes don't freeze, our heating unit's in the attic and it's not insulated, so it gets very cold there at night.

Quote:

Originally Posted by ShawnMcGrail
Ugh, you guys all got it lucky, my room temps are only 12c... so I'm always freezing my balls off when I go to sleep.. lol.
 

·
Registered
Joined
·
965 Posts
52f is your room temp??!?!?

I can leave my window open all night, wake up, and have a 68f room....

with 35f outside temp
 

·
Registered
Joined
·
965 Posts
Quote:

Originally Posted by ATVkid*AFZ*
what do you use to heat?
me?
central air

Although, I left my window half way open last night, with my door shut and my vents shut.. 68 when I woke up!
 

·
Premium Member
Joined
·
13,844 Posts
wow....you must burn a lotta oil heating your room...

Quote:

Originally Posted by Towlieee
me?
central air

Although, I left my window half way open last night, with my door shut and my vents shut.. 68 when I woke up!
 

·
Premium Member
Joined
·
13,844 Posts
probably not, i run loaded ~36 on my tower 112, with 1.6 vcore.
Quote:


Originally Posted by The Dark Inquisitor

.. I was stil in the 40's with my air.. does my chip just run hot .... or are my probes wrong or something

 

·
Registered
Joined
·
965 Posts
I can't wait tell I get a GOOD water block...

38c idle with 23c water, 46c full load..
with a chitty p4 1.4ghz

o well, I think my dads gonna get me the new PC
 

·
Premium Member
Joined
·
3,953 Posts
Quote:

Originally Posted by The Dark Inquisitor
ok so as we all know I have been having watercooling trouble

I decided to let the as5 sink in a little and now I'm doing alot better

I have been slowly pulling up the Vcore to check on how much I could Pull it up if I get new ram to break my 2.45 oc

I am at 1.6 now and my temps are 43 idle and 46 load

how is this now?
Hmmm. Since your load temp is only 3 degrees higher than your idle temp, that tells us that the water system is doing it's job. Now, you could still have some problems with a flat mount due to uneven lapping. It could also be a bad sensor that is causing this.
 

·
Premium Member
Joined
·
8,743 Posts
Quote:

Originally Posted by ATVkid*AFZ*
probably not, i run loaded ~36 on my tower 112, with 1.6 vcore.
I run loaded at 43°c with a 700mhz OC 3.2 @ 3.9

Theres gotta be something wrong with the setup...
Air...
Cavitation of the pump...
not sealed at all points would cause loss of pressure and you might not know it if its above the water line...

Shake the **** out of it
 

·
Registered
Joined
·
712 Posts


My house temp usually hovers at 70f... basement at 62f

my case usually runs at ambient temp (room temp) and the load temp only gets to about 4 degrees centigrade over that... all I have is air cool... but on;t OC so it may not matter.
 
1 - 18 of 18 Posts
Top