Overclock.net banner

1 - 11 of 11 Posts

·
Registered
Joined
·
505 Posts
Discussion Starter · #1 ·
My current loop is this:

RES: XSPC 5.25
PUMP: Laing DDC Pro Pump with XSPC V3 Acrylic Top
RAD: Thermochill PA120.3 with shroud & X3 Xiggy fans (61CFM) PUSH CONFIG
CPU BLOCK: Apogee XT

I am trying to improve my temps by a few degrees.

What fans would do a better job but I would like to try and keep the noise down.

Also I would like to install a water temp probe so I can monitor the temp entering the radiator and exiting the radiator.
 

·
Registered
Joined
·
505 Posts
Discussion Starter · #5 ·
Quote:


Originally Posted by frankenstein406
View Post

Yup thats what I meant. Just go with some higher cfm fans depending what your rad likes can you do push pull?

From what I have read the thermochill can use up to 130CFM fans.
Cant really do push/pull so I think push is better.

Just want it to be silent really or as silent as can be.

Also on a side note is the DDC Ultra 18w pump better than my current pump?
 

·
Registered
Joined
·
2,556 Posts
You could mod the pump to the 18W version by soldering two joints together:



For a nearly silent setup you could get some Gentle Typhoons. They should be more quiet and have better static pressure than the xiggies. I have some H1011s and they are far from being silent.
 

·
Registered
Joined
·
505 Posts
Discussion Starter · #11 ·
just ordered X3 Scythe Kaze Jyuni Slip Stream 1900rpm fans to b mounted on the radiator.

Also going to mod my pump to the 18W version.

Could you please have a look at my crude drawing of my setup and advise me on fan setup and if the OEM fans could be replaced with better options.
 
1 - 11 of 11 Posts
Top