Overclock.net banner
1 - 1 of 1 Posts

·
Premium Member
Joined
·
5,295 Posts
Your fan has 2 cables attached: long and short

There are 2 ways: (use only one of the 2 to control)

1. Control the fan speed by the supplied control module
(a) use the supplied 3-pin to 4-pin molex cable to connect the long cable to a power source (ie your PSU)
(b) connect the short cable from the fan to the included control module

2. Control the fan speed by your Scythe Kaze fan controller
(a) use the supplied full-speed-connector (red) to the short cable. The idea is to electrically short/bypass the resistor so that full speed is allowed at this end.
(b) connect the long cable to your Scythe Kaze fan controller

Refer to the following diagram , colour-coded for easy reference.
LL
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top