Overclock.net banner

1 - 5 of 5 Posts

·
Not new to Overclock.net
Joined
·
79,075 Posts
Discussion Starter · #1 ·
Sharp edge.jpeg
This is the top of the side panel. As you can see, I can't bend that part inward or else this will no longer go back on the case, so I need to put something on these parts between those parts that snap into the case. But what can I put on it? I'm vaguely remembering strips of a soft rubbery material that go onto thin edges like this, but I don't know how to find them.
 

·
Rig Advisor
Joined
·
3,542 Posts
View attachment 2487212
This is the top of the side panel. As you can see, I can't bend that part inward or else this will no longer go back on the case, so I need to put something on these parts between those parts that snap into the case. But what can I put on it? I'm vaguely remembering strips of a soft rubbery material that go onto thin edges like this, but I don't know how to find them.
This is the only thing that comes to mind, I have about 50 FT of it.

 

·
Registered
Joined
·
2,724 Posts
I used some trim from the auto parts store similar to what Avacado linked when I cut the hole for my EK pump/res combo.

2487213
 

·
Not new to Overclock.net
Joined
·
79,075 Posts
Discussion Starter · #4 ·
Oh, of course, it's called "trim". lol Thank you.
 

·
Iconoclast
Joined
·
31,138 Posts
I'd probably just use masking or gaffer tape, but I'm a cheapskate.
 
1 - 5 of 5 Posts
Top