Overclock.net banner
1 - 1 of 1 Posts

·
Registered
Joined
·
67 Posts
Discussion Starter · #1 ·
Evening all,

As some of you may know, I've recently put together my first rig (listed below). Being the novie that I am, I've tried to read up on any and all FAQ's found on OC.net (including NoAffinity's thread on OC).

I've disabled the Spectrum and went right into the JumperFree Config and set the 1:1 ratio. I got the FSB up to about 332 (3.0GHz) and it seems to be somewhat stable. Prime 95 works fine though Othros reports hardware failure after about 3min.

Despite increasing Vcore, anything above 332 FBS seems to be very unstable and unresponsive in the OS, frozen black screens on bootup or the OS failing to boot altogether.

I've also run CPU-Z and it reports my multiplier at 6, while I understand that C2D run at a X9. Can anyone please tell me what I'm doing wrong?
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top