Overclock.net banner
1 - 2 of 2 Posts

·
Registered
Joined
·
28 Posts
Discussion Starter · #1 ·
I have 2X2GB of Kingston KHX1333C7D3K2/4GX and I just want to set them at the timing referred by Kingston on their website... 7-7-7-20 at 1.65V.

Here is what I see in my Bios:

DRAM Command Rate [Auto]
DRAM 1St Information: 9-9-9-24-5-33-10-4

TCL [Auto]
TRCD [Auto]
TRP [Auto]
TRAS [Auto]
TRTP [Auto]
TRC [Auto]
TWR [Auto]
TRRD [Auto]

DRAM 2St Information: 8-2-5-4-4-110-0

TRWTTO [Auto]
TWRRD [Auto]
TWTR [Auto]
TWRWR [Auto]
TRDRD [Auto]
TRFC0 [Auto]
TRFC1 [Auto]
TREF [Auto]

*Dram Voltage [1.50]

And this is what I did:

DRAM Command Rate [Auto] (1T or 2T?)
DRAM 1St Information: 7-7-7-20-5-33-10-4

TCL [7 Clocks]
TRCD [7 Clocks]
TRP [7 Clocks]
TRAS [20 Clocks]
TRTP [Auto] (What I do here?)
TRC [Auto] (And here?)
TWR [Auto] (And here?)
TRRD [Auto] (And here?)

DRAM 2St Information: 6-2-5-4-4-110-0

TRWTTO [Auto]
TWRRD [Auto]
TWTR [Auto]
TWRWR [Auto]
TRDRD [Auto]
TRFC0 [Auto]
TRFC1 [Auto]
TREF [Auto]

*Dram Voltage [1.64] (I can't set 1.65... Maybe 1.66 would be a better choice?)

Is it ok? I did a mistake?
 

·
Premium Member
Joined
·
20,625 Posts
tRC should be set to 27
Leave everything else at auto it is just fine
1.64 is no issue... seriously, 0.01V, will NEVER make a difference
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top