Overclock.net banner

1 - 4 of 4 Posts

·
Registered
Joined
·
6 Posts
Discussion Starter #1
Hey everyone,

I'm having trouble with a bit of air in the line coming off of my gpu block and going into the second rad. When I tilt the case in the direction that seems like it would move the water where I want it, it retreats back into the gpu block. My setup is a bit unconventional in terms of the res. It's a swiftech micro with what would usually be the fill port being used as the inlet. I have a ball valve coming off of one of the side holes with some tubing. I included a pic for reference. Any suggestions?
 

·
Banned
Joined
·
3,726 Posts

·
Registered
Joined
·
2,099 Posts
Hi there

As above this does looks like low flow and my main suspicion is GPU block is causing low flow, what pump are you running?

Alphacool radiators are not very restrictive, CPU block too is low restriction block

Hope this helps

Thanks, Jura
 

·
Overclocker in training
Joined
·
13,929 Posts
Hi,
Make sure the pumps pwm fan or pump port is not plugged into the mother board which it doesn't look like it is on the bottom anywhere.
Only wire that should be connected is to the molex power and of course the cheat trip connection to fake out the power supply.
 
1 - 4 of 4 Posts
Top