Overclock.net banner
1 - 3 of 3 Posts

·
Registered
Joined
·
990 Posts
Discussion Starter · #1 ·
Hello everyone,

I put back my 965 to 3.8Ghz, I ran 50 passes of LinX and passed all of them. But for some reason I can't pass 30 minutes of Prime95 Blend with 2000mb of ram tested. Any help will be appreciated.

 

·
Banned
Joined
·
5,701 Posts
You're memory isn't stable then I would assume. Loosen the timings or increase volts if you aren't already at the manufacturers specs.

Try LinX with more memory tested and it would probably fail.
 

·
Registered
Joined
·
309 Posts
Also to i find that prime95 needs a little more vcore to pass that LinX or IBT. You might try bumping you vcore up a notch or 2. also i would drop you ram to the lowest that it will run while trying to overclock you cpu. I is a little easier then because you are only messing with one component at a time and then bring you ram up later after you get you cpu where you want it at and stable.
Hope this helps


Also if you could post a screen shot of your memory and spd tab is cpuz
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top