Enable LoadLine Calibration.
1 - 20 of 22 Posts
Quote:
wait it should be enabled? i thought it was another thing for voltage droop and it should be disabled?
Originally Posted by tK FuRY  Enable LoadLine Calibration. |
Quote:
ohh yeah i disabled though. what exactly is loadline calibration?
Either way during hte stress test it passed 1 hour at 1.14v when it dropped
Originally Posted by tK FuRY That would be C1E and SpeedStep. |
Either way during hte stress test it passed 1 hour at 1.14v when it dropped
Quote:
ohh okay sweet thanks ill enable it for him when he comes over again next week with the dark night he ordered today so we can start overclocking.
Originally Posted by tK FuRY its like a vdroop mod built into the board. It decreases the amount of voltage is dropped upon load. |
Quote:
okay sweet.... ill just enable it
Originally Posted by R00ST3R That's nice 
It's a feature to reduce vDorop as said before
|
3
Quote:
We actually have a forum member who is doing tests to see if in fact it is dangerous to use LLC on 45nm chips.
Originally Posted by R00ST3R That's nice
It's a feature to reduce vDorop as said before
|
We actually have a forum member who is doing tests to see if in fact it is dangerous to use LLC on 45nm chips.
3
Quote:
hmmm... how would it be dangerous?
Originally Posted by tK FuRY We actually have a forum member who is doing tests to see if in fact it is dangerous to use LLC on 45nm chips. |
Quote:
ohh hmmmmmmm
Originally Posted by tK FuRY Supposedly, LLC causes spikes in the voltage going to the CPU. Instead of the voltage decreasing under load, it actually increases during load. Over what the set limit/loadline is which is a spike. These spikes sometimes go wayyyy over and causes short but sometimes dangerous overloads to the CPU. |
Quote:
thats what i was kind of thinking
Originally Posted by u238 Vdroop is a design feature. LLC disables it, causing higher voltage spikes when the processor utilization drops. I would rather just raise the voltage higher and deal with the vdroop than disable a safety feature. |
I tried it once and it actually dropped worse than with it disabled and failed a stress test.
![]()
LoadLine Calibration Enable
![]()
Quote:
What did you use to measure the voltage, and how do you know it's accurate? You may be surprised if you take a reading directly from the motherboard with a voltmeter.
Originally Posted by da tick 07 it can get confusing between vdroop and vdrop but i use LLC without any problems. actually i couldnt get my cpu stable at 1.45 volts without it and with it im under 1.425 volts |
1 - 20 of 22 Posts
