Overclock.net banner

1 - 3 of 3 Posts

·
Registered
Joined
·
517 Posts
Discussion Starter #1
Is anyone using it? It's been out since the end of 2014, but haven't seen it mentioned here at all. It's also not being recognized by the software (1.24) at all. Wondering if this is normal?
 

·
Registered
Joined
·
108 Posts
Yes, there's somebody using it: http://www.overclock.net/t/1525645/new-mionix-firmware-for-avoir-7000-and-naos-7000/20#post_25137558
Have you tried to put the mouse in to bootloader mode?
nstallation:

To set the mouse in to bootloader mode, please do the following:

1: Hold down the right mouse button, left mouse button and the scrollwheel button at the same time.

2: While you are holding the buttons, plug the mouse in to your USB port.

3: The logo LED and the scroll wheel LED of the mouse should now be blinking.

4: Then run the firmware update software that can be found on you desktop.
 
  • Rep+
Reactions: Nguruthos7

·
Registered
Joined
·
517 Posts
Discussion Starter #3
Thanks. I put it in bootloader mode, but the software still doesn't recognize the mouse. It works fine, but I just want to change DPI and light settings, which I can't do. I updated firmware twice and reinstalled the software numerous times, but no luck.

Edit: nvm, got it.
 
1 - 3 of 3 Posts
Top