Overclock.net banner

1 - 2 of 2 Posts

·
Registered
Joined
·
502 Posts
Discussion Starter #1
So, I've got my ram running at 3060mhz 14-14-14-30 2T 100% stable. I'd really like to get 3200mhz stable if possible. I am able to boot into windows using cldo_vddp 960mv, but while in windows, attempting to run any stress test program fails to fully load the cpu. For example, running p95 just results in over half the workers dropping.

Any thoughts on how I can stabilize this? I have proc odt at 68ohms and cad bus at 40ohms. Seems like setting proc odt any higher makes it so windows fails to load.
 

·
Registered
Joined
·
7 Posts
I guess nobody here went maxed out like you did on the ram. Good luck mate. If you pushing this far why not got for the high end asus board in the first place since there is many bios settings there you wont get in other board. Personally myself having asus board let me push the high speed memory compare to msi board i had before.
 
1 - 2 of 2 Posts
Top